BPC PowerMaster Uživatelský manuál stáhnout pdf (Strana 10)

Assigning a unique ENG or TR ID# to the LEGACY PowerMaster output

1. Connect the “U” terminal of a LEGACY Command Base (#992 from set 6-14295) or a LEGACY

BASE-1L (6-37156) to the “U” terminal of the PowerMaster or to the outside rail of the track.

2. Plug in the LEGACY Base and turn on the power to the LEGACY PowerMaster.

3. Set the PROG/RUN switch on the PowerMaster to the PROG position.

4. Press ENG or TR on the CAB-2 OR CAB-1L Remote Control.

5. Enter the unique ID#. You may select any ENG ID# from 1 to 98 or any TR ID# from 1 to 99.

Version 1.4 LEGACY system update is required to use TR ID#s 10 to 95. Using these ID#s

with LEGACY system Version 1.3 or lower will result in unexpected operation.

6. Press SET. The red light on the top of the PowerMaster will ﬂash to indicate that the ID# has been

set.

7. Slide the PROG/RUN switch back to the RUN position. The PowerMaster has now been assigned

the ID# you selected.

8. Continue to the following section to set the device type and control mode

Note!

LEGACY Control System set-up

efore you operate the LEGACY PowerMaster with the LEGACY Control System, you will

need to set the device type, control mode, and assign it a unique ID#.

The LEGACY PowerMaster receives signals from the LEGACY 455 MHz track signal.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Žádné komentáře

BPC PowerMaster Uživatelský manuál Strana 10